Document Part No: 11028504B MODEL VX402C-64 USER’S MANUAL ACTIVE MODULE CARRIER C&H Technologies, Inc. <> 445 Round Rock West Drive <
10 Table I. Power Supply Capabilities VX402C-64 Version -0001 -0002 -0003 -0004 VXI +5V Supply Capability 42.0W 42.0W 42.0W 42.0W VXI +24V S
11 2.0 INSTALLATION 2.1 UNPACKING AND INSPECTION In most cases the VX402C-64 is individually sealed and packaged for shipment. Verify that there h
12 C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
13 3.0 FUNCTIONAL DESCRIPTION 3.1 GENERAL VX402C-64 is a general purpose carrier module for VXI C-Size chasses. The module provides actively buffe
14 3.2 TRIGGERS Both ECL and TTL triggers are supplied through the VX402C-64. There are switches on the carrier which are used to set the di
15 3.2.2 ECL TRIGGERS The VX402C-64 supports two ECL Trigger lines: ECLTRG0-1. Each trigger line may be set as an input or output trigger. The tri
16 3.3.3 PASS-THROUGH CONNECTORS One major difference between the VME bus and the VXI bus is that the outer rows of the P2 connector are not defined
17 A one-to-one cable that connects Pin 1 (C32) on the VXI side to Pin 1 (C32) on the VME side, and so on, could only be used if the VME module was d
18 3.4 SUMBUS CONFIGURATION The VX402C-64 provides a direct connection of the SUMBUS signal through the pass-through connector to the front connecto
19 3.4.2 SUMBUS JUMPER SETTINGS In order to use the SUMBUS signal, the jumpers J11 and J12 must be configured properly. The three different setting
ii COPYRIGHT C&H Technologies, Inc. (C&H) provides this manual "as is" without warranty of any kind, either expresse
20 C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
21 4.0 OPERATING INSTRUCTIONS While the VX402C-64 is an active carrier, it is designed to be completely transparent to the host interface. For this
22 C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
A-1 APPENDIX A - CONNECTORS PIN C B A 1 2 3 4 5 D08 D09 D10 D11 D12 - - ACFAIL* BGIN0* BGOUT0* D00 D01 D02 D03 D04 6 7 8 9 10 D13 D14 D15 GND
A-2 PIN C B A 1 2 3 4 5 CLK10+ CLK10- GND -5.2V LBUSC00 +5V GND RSV1 A24 A25 ECLTRG0 -2V ECLTRG1 GND LBUSA00 6 7 8 9 10 LBUSC01 GND LBUSC02
A-3 PIN D C B A Z 1 2 3 4 5 - GND - - - BD08 BD09 BD10 BD11 BD12 - - BACFAIL* IN0* OUT0* BD00 BD01 BD02 BD03 BD04 - GND - GND - 6 7 8 9 10
A-4 PIN D C B A Z 1 2 3 4 5 - - - - - CLK10+n CLK10-n GND14 -5.2V5 LBUSC00n +5V GND RSV1 BA24 BA25 BECLTRG0 -2V2 BECLTRG1 GND13 LBUSA00n - GND
A-5 TO FRONT CONNECTOR J2 TO REAR CONNECTOR P2 PIN PIN PIN PIN 1 3 5 7 9 -24Vn +24Vn GND02 RSV3n GND03 2 4 6 8 10 BSUMBUSn GN
A-6 C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
N O T E S : C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
iii AMENDMENT NOTICE C&H Technologies, Inc. makes every attempt to provide up-to-date manuals with the associated equipment. Occa
C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com
READER'S COMMENT FORM Your comments assist us in improving the usefulness of C&H's publications; they are an important pa
INSTRUCTIONS In its continuing effort to improve documentation, C&H Technologies, Inc. provides this form for use in submitting any comments o
iv INTRODUCTION This manual describes the operation and use of the C&H Model VX402C-64 VXI Active Carrier Module (Part Number 11028500 Revision
v TABLE OF CONTENTS 1.0 GENERAL DESCRIPTION ... 7
vi LIST OF FIGURES Figure 1. Front Panel and Top View (Top Shield Not Shown) ...7 Figure 2. Po
7 1.0 GENERAL DESCRIPTION The VX402C-64 Active Carrier allows an A- or B-size VME, VXI, or VME64 module to be used in a C-size VXI mainframe chassis
8 1.2 SPECIFICATIONS OF EQUIPMENT 1.2.1 Key Features Provides direct access to the VME module’s front panel I/O connections Supplies buffered da
9 Figure 3. Power Schematic (-0002 version) Figure 4. Power Schematic (-0003 & -0004 versions) VXI BACKPLANE +5V +5V VME64 CONNECTORS
Comments to this Manuals